Inside The Made To Order Process For A Handcrafted Helmet

The trade off is scale. A workshop like this will never produce helmets as fast as a large factory, and that is treated as acceptable, since the aim is a considered, well finished helmet rather than the fastest one to market.

For helmet care products and guidance, see full face helmet.

Most manufacturers recommend replacing a motorcycle helmet every five to seven years even without a crash, since the internal materials that absorb impact degrade slowly with heat, sweat and UV exposure. The shell can look fine while the protective layer underneath has already lost some of its effectiveness.

A helmet that is the right size should feel snug all the way round with no single pressure point, and it should not shift when you turn your head firmly from side to side. A helmet that moves independently of your head on a shake test is not the right fit, regardless of what the size label says.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.